Blue Point

Buying Guide: Powder Actuated Pins and Tools

Drive Pins
Blue Point drive pins are electro galvanized for rust resistance indoors and have a ballistic point for consistent fastening. Lengths include 1/2 in., 3/4 in., 1 in., 2 in. and 3 in., and a plastic/steel version is available in the 1/2 in. length. The PD157 pin has a .157 in. shank for hard structural steel, where the thicker shank resists bending.

Drive Pins with Washer
These pins have a .145 in. shank and a 1 in. diameter metal round washer. Lengths include 1 in., 1-1/4 in., 1-1/2 in., 2 in., 2-1/2 in. and 3 in. They are used with most powder actuated tools, and the washer and pin are electro galvanized for indoor rust resistance.

Powder Actuated Tools
The BP-301C is a semi-automatic .27 caliber strip tool that installs .300 in. headed drive pins and 1/4 in.-20 threaded studs up to 2-1/2 in. total length. The BP-302A is a semi-automatic .27 caliber tool that uses standard 10 shot strip loads, and the BP-307S is a single shot, low velocity .22 caliber tool for maintenance and residential or commercial work.

Frequently Asked Questions

What does Blue Point make?
Blue Point offers steel flat head drive pins, drive pins with washers, and powder actuated tools. The pins are sold in boxes of 100 and are made for use with powder actuated tools on steel.

How do I choose the right pin?
Match the pin length and head to the thickness of your material and the pin type your tool takes. Check your tool manual for the correct pin type, and use the .157 in. shank for hard structural steel when that applies.

Which tool should I choose?
Choose the tool that matches the pin type you need. The BP-302A uses standard .27 caliber 10 shot strip loads, while the BP-307S is a single shot .22 caliber tool. Always follow the manufacturer's instructions and the tool manual when operating powder actuated equipment.