The SharkBite Ice Maker Installation Kit has everything you need to install the water supply to your ice maker. The SharkBite Service Slip Tee allows you to remove up to 2 in. of your existing copper or CPVC line and add an angle supply stop valve. Just insert the pipe and the stainless steel teeth bite down and grip tight, while a specially formulated O-ring compresses to create a perfect seal. Disassembly is just as fast using the simple disconnect tool so fittings and valves can be easily changed and reused. They can even be rotated after assembly for easier installation in tight spaces. The included 10 ft. PEX coil connects to the push-to-connect angle stop valve 1/4 in. outlet and the 1/4 in. ice maker connector which will thread onto your ice maker. The pipe can be cut to the exact length needed so there is no excess supply line to coil providing a clean, tangle free look.
May cause Cancer and/or Reproductive Harm - www.P65Warnings.ca.gov
